Komatsu 830E, Руководство по ремонту

Страница: 90 / 783

Adjustment
1. Vehicle must be parked on a flat, level surface for
inspection.
2. All pads, except the rear pad on each side, should
contact the frame with approximately equal com-
pression of the rubber.
3. A gap of approximately 0.06 in. (1.5 mm) is re-
quired at each rear pad. This can be accom-
plished by using one less shim at each rear pad.
4. If pad contact appears to be unequal, repeat the
above procedure.
Proper body pad to frame contact is required to
assure maximum pad life.
BODY GUIDE
1. Body guide wear points should be inspected each
time a body pad inspection is performed. (Refer
to Figure 3-5.) The body guide should be centered
between the wear plates (3), with a maximum gap
of 0.19 in. (4.8 mm) at each side when new.
2. If gap becomes excessive, replacement parts
should be installed. (Refer to the Parts Catalog.)
BODY-UP RETENTION CABLE
Any time personnel are required to perform main-
tenance on the vehicle with the dump body in the
raised position, the body-up retention cable MUST
be installed.
1. To hold the dump body in the up position, raise the
body to its maximum height. (Refer to Figure 3-6.)
2. Remove the cable (3) from its stored position on
the body and install between the Rear Body Ear
(1) and the Axle Housing Ear (4).
90440
FIGURE 3-5. BODY GUIDE
1. Dump Body
2. Body Guide
3. Body Guide Wear
Plates
FIGURE 3-6. BODY-UP CABLE INSTALLATION
1. Rear Body Ear
Structure
2. Cable Storage
4. Axle Housing Ear
Structure
B3-4 Dump Body B03018