Kollmorgen MMC Smart Drive Series, Руководство по оборудованию

Страница: 81 / 386

Kollmorgen - June 2014 79
MMC Smart Drive Hardware Manual
-
230V 3 PHASE MMC SMART DRIVE NEXTGEN
5 230V 3 Phase MMC Smart Drive NextGen
The 230V Smart Drive NextGen (the Drive) is an AC Servo Drive capable of driving a
wide range of Brush-type and Brushless DC motors.
The Drives’ Power Section features the following:
• May be connected to a wide range of Mains power:
• 100-240VAC, 50/60Hz, 1 or 3 phase
• Built-in regen resistor (12A and 24A models only)
• Supports external regen resistors if required by application
• Brake Output (this can also be used as a General Purpose Output)
• Supports DC bus sharing
• Safe Torque Off capability
The Drive’s Control Section features the following:
• Connects to Kollmorgen’s Digital Link bus
• Two-digit error/status display
• A primary feedback connector (F1), containing the following features:
• High density female DB-15 connector
• Supports the following feedback devices:
• Incremental Encoder (without halls)
• Stegmann Hiperface encoder
• High Resolution Resolver
• 1V p-p Sinewave Encoder
• Endat 2.1 (2.2 in future release)
• BiSS (Mode B)
• SFD (Smart Feedback Device). Note: An SFD can be connected to F1 or
F2, not both
• A secondary feedback connector (F2), containing the following features:
• High density female DB-15 connector
• This connector can support one of the following functions:
• Emulated F1 encoder output
• Comcoder Input (Incremental Encoder with halls)
• SFD Input (Smart Feedback Device). Note: An SFD can be connected to
F1 or F2, not both.
• I/O connectors, containing the following features:
• Two pluggable 10-pin screw-terminal connectors
• Two Fast DC Inputs (sink or source in group of two)