Kollmorgen MMC Smart Drive Series, Руководство по оборудованию

Страница: 232 / 386

230 Kollmorgen - June 2014
MMC Smart Drive Hardware Manual
-
460V 3-PHASE MMC SMART DRIVE
8.2.2.2 Motor Connector
NOTE
The shunt resistor (if installed) across Ba+ and Ba- will be connected across
the DC bus when the DC bus reaches the “shunt switch threshold” as shown
in the specification table; or when the “Shunt On” input on the J1 connector
is active.
NOTE
If a 460V drive is connected to 220V to run a 220V motor, enable the “220V
Shunt on 440V Drive” feature using PiCPro, connect GPOUT3 on the Drive
I/O (IO) connector to the “Shunt On” input on the J1 connector, and install
the appropriate shunt resistor across the Ba+ and Ba- terminals. The shunt
resistor will be applied across the DC bus when the DC bus voltage rises
above 415 volts, and will be removed when the DC bus voltage falls below
400 volts.
Table 8-7: 460V Size 2 Motor Connector
Signal Type
Signal
Description Connector
Label
In/Out Connector
Ground
Protective
Ground (Earth)
PE Out
Motor
Power U-phase
from the drive to
the motor
1U2 Out
Power V-phase
from the drive to
the motor
1V2 Out
Power W-phase
from the drive to
the motor
1W2 Out
PE
1U2
1V2
1W2