Kollmorgen MMC Smart Drive Series, Руководство по оборудованию

Страница: 223 / 386

Kollmorgen - June 2014 221
MMC Smart Drive Hardware Manual
-
460V 3-PHASE MMC SMART DRIVE
8 460V 3-Phase MMC Smart Drive
The 460V MMC Smart Drive is available in both analog and digital interfaced versions,
with power ratings from 1.3kW through 100kW. This section describes these drives in
detail.
Features include:
•
460V, Three Phase drives available with power ratings of 1.3kW through 144kW
•
Drive firmware in user upgradeable Flash memory
•
Serial port for communications with PC-resident PiCPro
•
Internal switch to control a mechanical brake
•
Green Power LED and yellow Diagnostic LEDA primary feedback connector (F1),
containing the following features:
•
High density female DB-15 connector
•
Supports the following feedback devices:
•
Incremental Encoder (without halls, Enhanced Feedback models only)
•
Comcoder Input (Incremental Encoder with halls, not on Enhanced Feed-
back models). Note that halls can be connected to F1 or F2, but not both.
•
Stegmann Hiperface encoder
•
High Resolution Resolver
•
1V p-p Sinewave Encoder
•
Endat 2.1 (2.2 in future release)
•
BiSS (Mode B)
•
A secondary feedback connector (F2), containing the following features:
•
High density female DB-15 connector
•
This connector can support one of the following functions:
•
Emulated F1 encoder output
•
Comcoder Input (Incremental Encoder with halls). Note that on non-
Enhanced Feedback models, halls can be connected to F1 or F2, but not
both.
•
Eight General Purpose 24VDC Inputs
•
Four General Purpose 24VDC outputs
•
+10V command input (Analog Interfaced MMC-SD only)
•
Digital Link digital connections (Digital MMC-SD only)
•
Optional MMC-SD Control (for Digital MMC-SD only)
•
UL Listed and CE Marked.
8.1 Control Section Connectors, Switches, LEDs
The Control Section is located on the right side of the drive, and is identical to the
Control Section on the 230V Smart Drive. Refer to
section 7.1 on page 166 for