TF.16 IFU StarDevice.003.10-EN 2021-01-12
prepared by Pulavskyi A., Kolyesnik O.
36
5.10
MESSAGES
The manipulator stops working if the manipulator cable is not
connected to the socket on the back panel of the electronic unit when
the device is turned on or during operation then the initial window is
displayed with a message about the unconnected manipulator and there
is a repeated sound signal (sound power less than 85 dB). To be able
to perform an operation it is necessary to connect the manipulator cable
to the corresponding socket on the back panel of the electronic unit.
The message about the connected manipulator will be displayed on the
opening window after connecting the cable and further operation of the
device will become possible (see 5.5). The beep sound turns off.
5.11
COMPLETION OF WORK WITH THE DEVICE
To complete the work with the device you need:
• To switch off the device using the power button on the back panel of the electronic unit
• To remove the tip from the manipulator and wipe it with a water-alcohol solution (see also
item 6.2).
• To fold tips and the manipulator for storage for next use.
5.12 STARDEVICE-PC SOFTWARE STARDEVICE VER. 1.3
FIRST START OF THE STARTEVICE SOFTWARE V1.3.
To install the software on your computer, run the installation package. An icon will be created on
the desktop of your computer to start the program after the installation of the StarDevice V1.3
program is completed.
Connect the device StarDevice
®
to your computer by using a USB cable. Turn on the device
StarDevice
®
, as it is described in section 5.6.
Run the software V1.3 of the device StarDevice
®
.
