Subject to change without notice.
5
KWV-20G*ATA**
REV — 02/26/20
INSPECTION OF EQUIPMENT
Upon receipt of unit, inspect for visible or
concealed damage. Report any damage to the
carrier and file a damage claim.
MOUNTING THE EQUIPMENT
The unit is a self-contained air cooled system. It
should be mounted on a level surface.
INSTALLATION OF UNITS
The standard configuration of the portable vertical
unit is shown in Figure 1 - Standard Portable.
1. The unit shall be shipped as a single pack-
aged unit.
2. The unit is fully charged with R410A when
shipped.
3. The unit is provided with forklift pockets at the
bottom for moving the unit to the desired loca-
tion for installation.
4. Connect the condensate drain line for the unit.
A “kazoo” tube is shipped loose with the unit.
Run hose from the condensate drain connec-
tion to the desired condensate disposal loca-
tion and attach the “kazoo” tube to the end of
the hose.
NOTE:
The “kazoo” tube acts as a condensate
trap and is required.
5. Refer to the unit data plate for main power re-
quirements. Electrical wiring and grounding
must be installed in accordance with the latest
revision of the AS/NZS 3000 standard. Route
the incoming power to the unit’s main power
connection.
Make sure the power supplied
to the unit matches the unit power require-
ments for this unit .
Figure 1 – Standard Portable
6. Install the tent material under the tent clamps
on each side of the cabinet. A 7/16“ wrench is
required to loosen the bolts securing the tent
clamps.
NOTE
: Do not over- torque tent clamp bolts.
OPERATING INSTRUCTIONS
Before electrical power is applied to the unit, make
sure the unit is connected to an earth ground. The
circuit breaker should be in the “OFF” position.
Electrical power is supplied to the unit from a
power source (shore power or generator) via a
connecting cable, which terminates in the factory
supplied power connection. Connect the main
power wires to the power connectors. See Figure
2 – Power Input Location. This supplies power to
the entire unit. Make sure that the power that will
be supplied to the unit matches the electrical data
label provided in the unit.
Содержание KWV-20
Страница 12: ......
