Kokido Manga RC30, Руководство пользователя

Страница: 26 / 28

25
3.
Move out the battery pack to expose the PCBA. To detach the battery connection
wire, press the clip on the connector and then pull it out. NOTE: Wrap the connector
immediately with insulating tape in order to avoid short circuit caused by contact of both wire
terminals.
TROUBLESHOOTING
Problem Possible Cause Solution
Robot does not capture the debris Battery is running out Charge the robot again.
Impeller is jammed Power off the robot and visually check the hole under the
swivel head to see if the impeller is jammed by larger
debris. If necessary, contact your dealer for further
instructions.
WARNING! Make sure the robot is powered off when the
unit is being serviced.
Impeller is broken Contact your dealer for replacement.
Debris compartment is full Clean both debris compartment and filter cover.
Robot stopped moving in the middle of
pool but swivel head is still turning Robot stopped by obstacle Check to see that if there is nothing obstructing the
cleaner. Remove the obstacle.
Robot is stopped by suction
force from pool floor main drain Turn off the filtration system as instructed in manual.
Robot does not cover the entire pool /
move along the pool wall Debris compartment is full Clean the debris cleaner
Operation time is shorter as
expected Clean the filter compartment and recharge the robot
again for 4.5- 5 hrs
Moving direction is interrupted
by water circulation generated
by filtration system
Turn off the filtration system as instructed in manual.
Wheel is jammed Check and clean out debris from the wheel.
Locking pin position is not
correct / bumper is required Follow instruction to set up the locking pin position properly
and apply bumper .
Robot moves along the pool
wall of round pool Make sure the bumpers have been installed as instructed
in manual.