将角阀
(9)
与管道出水口连接，再
将软管
(10)
与角阀
(9)
连接，在软
管
(10)
前放一水桶，将角阀
(9)
完
全打开，打开供水系统，通水约一
分钟，确认管道连接触无渗漏后，
关闭供水系统。
10
Connect check valve (9) and outlet
together, then connect the hose (10) and
check valve (9). Put a bucket in the front
of hose (10), turn on the check valve (9)
completely and open the water supply.
After the water flushing about 1 minute,
make sure no leakage and turn off the
water supply.
4.
用螺丝刀拧下阀盒盖螺钉
(7)
，将
阀盒盖
(6)
打开。根据安装尺寸图
确定控制阀组件
(5)
安装位置，打
孔，打入膨胀管，使阀盒紧贴墙
面且控制阀组件出水口朝上，再
用膨胀螺钉
(8)
将控制阀组件固定
在墙壁上，注意控制阀组件要与
墙面保持平行。
控制阀组件的安装固定
4. Fix the control box
Remove the cover (6) after loose the
screws (7). Determine the installation
location of control box (5) per rough-in,
then drill holes and place sheath in it.
Make the control box cling on the wall
and outlet upturned, then fix the control
box on the wall by screws (8), keep the
control box parallel to the wall.
5
6
7
再将软管
(10)
与阀体进水口连接，
然后连接阀体出水口与龙头组件
出水软管
(11)
。
注意：
1.
出水软管处的平垫不要遗漏。
2.
3.请勿将进水口与出水混淆。
取出电池盒组件，拧开螺钉
(12)
，
按电池盒盖
(13)
上的正负极标示分
别装入
2
节
5
号电池
(14)
，锁紧电池
盒盖
(13)
的螺钉
(12)
后，将电池盒
组件放入阀盒的专用槽内。
注意:
电池正负极不能装反，新旧电池不
能混用。
出水口
Outlet
进水口
Inlet
12
13
14
15
16
10
9
11
圆孔
Round Hole
六角形孔
Hex Hole
Take out the battery box and loose the
screws (12), place two “AA” batteries into
the box according to the negative and
positive pole mark on the cover of battery
box (13). Put the box in the particular
groove in the valve box after tight the
screws.
Note:
Do not mistake the pole and mixture the
new and used batteries.
8
8
6
1205259-2-A
请用户自备角阀。
Connect hose (10) to the inlet of valve,
then connect the outlet of valve and
inlet (11) of spout assy.
Note:
1.
3. Do not confuse the inlet and outlet.
2.
by themselves.
Do not lost the washer of hose.
Please let user prepare check valve
9
9