1374956-T01-B
-11-
第九步：
电路连接检查：
1.
先将电网电源总电关闭后操作，电源线必须连接至配有断开
装置的固定布线网络；对接好后盖上外壳盖板，对接处必须
做好防潮防漏电保护；
2.
接好后上电检查主控盒，如按键板指示灯亮，无闪烁灯说明
线路接连正常，分别测试程序
A
和
B
、风机高速和低速、加
热开和关；
3.
显示板通讯故障提示功能：如果主控板和显示板通讯连接不
上，则按键板风速低的指示灯闪烁提示通讯故障；
4.
洗手盆堵塞提示功能：如果洗手盆堵塞导致溢水开关动作，
则按键板加热开的指示灯闪烁提示通讯故障；
5.
皂液少提示功能：如果洗手皂液过少，则按键板风速高的指
示灯闪烁提示；
6.
风机故障提示功能：如果风机出现故障不工作，则按键板加
热自动指示灯闪烁提示风机故障。
第十步：
1.
检查所有功能正常后；关好柜门保存好钥匙。
Step 9:
Check the circuit connection:
1. Operate after the general switch of power grid is turned
off. The power cord must be connected to the fixed wiring
grid with an air switch. Close the enclosure cover. The
connection must be protected against moisture and earth
leakage.
2. After connection, power on and check the main control
box. If the keypad indicators turn on without blinking,
it indicates that the circuit is connected normally.
Respectively test program A and B, high and low speed of
the fan, heating on and off.
3. Display board communication failure prompt: If the
communication fails between the main control panel and
the display board, the low wind speed indicator will blink to
prompt a communication failure.
4. Lavatory block-up prompt: If the lavatory block-up causes
the action of overflow switch, the heat ON indicator on the
keypad will blink to prompt a communication failure.
5. Low soap prompt: If the soap is not enough, the high wind
speed indicator on the keypad will blink to prompt.
6. Fan failure prompt: If the fan fails to work, the automatic
heating indicator on the keypad will blink to prompt a fan
failure.
Connect the power cord must be
connect to the fixed wiring grid with an
air switch. The connection must be
protected against moisture and earth
leakage. Make sure that the live wire
and neutral wire are connected properly.
фսङऄ࢛িକݎਙ߄ލڐङ֡ؔ
٢িৠৌͫٷҟױஅ䉸அࢥऄґܔ
;
ेґ
ࢮি澝னিثݎ࠳े澞
Step 10:
1. Check all functions, close the cabinet door and keep its
key.