Kohler CORALAIS K-15290, Руководство пользователя, Страница: 3 / 24

3
1012829-2-
B
Kohler Co., Kohler, WI U.S.A.
NOTE: This frame applicable to rough (unfinished) deck
installations only.
Set Valve Body Height: Use one of the following two
formulas to calculate the valve body clearance required
for the finish material at your installation.
If tile to be installed measures less than 1” (2.5cm) thick,
add that measurement to 1-1/4” (3.2cm).
Example #1: Tile thickness (3/4” (1.9cm)) + 1-1/4” (3.2cm)
= 2” (5.1cm) clearance.
If the tile to be installed measures between 1” (2.5cm) and
1-1/4” (3.2cm) thick, add only 1” (2.5cm) to 1-1/4” (3.2cm).
Example #2: Tile thickness (1-1/8” (2.9cm)) =1” (2.5cm)
+ 1-1/4” (3.2cm) = 2-1/4” (5.7cm) clearance.
Adjust threaded collar until the dimension from the top of
the sleeve to the top of the rough deck surface equals the
clearance requirement you calculated.
Note this dimension. You will need to use it again after
connecting the supply tube.
Fig. #5
ÀÀÀÀÀ
ÀÀÀÀÀ ÉÉÉÉÉ
ÉÉÉÉÉ
ÉÉÉÉÉ
Tile Thickness
2-1/8”
(5.4cm)
Max.
2” (5.1cm)
Clearance
1-1/4”(3.2cm)
Top Of Sleeve
Threaded Collar
Rough Deck
3/4” (1.9cm)
EXAMPLE #1
ÀÀÀÀÀ
ÀÀÀÀÀ ÉÉÉÉÉ
ÉÉÉÉÉ
Tile Thickness
2-1/8”
(5.4cm)
Max.
2-1/4” (5.7cm)
Clearance
1-1/4” (3.2cm)
Top Of Sleeve
Threaded
Collar
Rough Deck
1-1/8” (2.9cm)
EXAMPLE #2
NOTE: This frame applicable to rough (unfinished) deck
installations only.
Supply Tube Connection: Measure distance from
bottom of spout supply tube to top of tee.
Add 1” (2.5cm) to this measurement and cut a piece of
1/2” nominal (5/8” O.D.) copper tubing to fit into the supply
tube and tee port.
Fig. #6
Spout Supply Tube
Tee
Measure
Distance
NOTE: This frame applicable to rough (unfinished) deck
installations only.
Back off threaded collars as far as possible without
removing them. Pivot the valve bodies enough to remove
the tee and two pieces of tubing. (If valve body holes are
smaller than recommended, it may be necessary to
remove the entire valve body assembly.)
Install tubing into tee. Mate copper tube from tee with
spout supply tube. Pivot the valve bodies onto the two
pieces of copper tubing.
Do not solder at this time.
Fig. #7
Sleeve
Threaded
Collar
Rough
Deck
Mounting
Nut
Copper
Tube
Spout Supply
Tube
Tee