1 . Determine the installation location per rough-in dimensions.
Chisel out a slot and install the supply tubing . Turn off the
water supply. The depth of the slot is no less than 90mm,
see the figure right for rough-in dimension requirement.
NOTE:
Installation location: No strong ultraviolet radiation or
electromagnetic field nearby.
2 . Put the flush valve into the slot. Then connect the water
supply and make the outlet aligned with the center of the
urinal stall. Secure the flush valve with supporting block to
make it flat and straight. Then connect the inlet pipe .
According to the dimensions of the urinal stall, the outlet
fitting are connected and installed as shown in the
rough-in. (See “ROUGHING-IN”)
NOTE:
a. Don’t mistake the direction of inlet and outlet.
b. Please clean the inside of water supply pipe before
connecting to the product.
INSTALLATION
安装步骤
1.
根据安装尺寸图确定安装位置，凿出槽坑，埋设供水管，
暂不供水。（槽深不小于
90mm
），尺寸参考右图。
安装交流型时，添加右图虚线内槽坑用于安装电工套管。
注意：
安装位置
:
a. 不能靠近强烈紫外线或电磁场。
b. 不能有光源直射或反射进感应窗口。
c. 不能在感应器正对面有易反射的物品（如镜子、
光亮不锈钢板及其他镜面物体）。
Nut
Outlet Connection
Water Supply (Recommended Inner
Diameter Is More Than 25mm)
Battens
垫紧块
出水连接
螺母
供水管（推荐内径大于
25mm
）
Installation Site
90
安装区
90
90
75
Install bushing
适合安装
电工套管
≈
28
≥
90
Connect control box while
installing AC
安装交流型时接面板上的电控盒
Outer diameter of Bushing
is No More Than 25mm
电工套管外径≤
25mm
AC Power Unit
交流电源盒
2.
将冲洗阀放入槽坑内，然后连接进水口，出水口对准小
便器中心。用垫紧块将其固定平整、端正，接好进水管道。
出水配管的连接根据小便器的不同选择安装如尺寸图所示。
（参见”尺寸图”）
注意：
a.
不要将进出水方向弄错。
b.
将本产品连接上供水管前，建议先冲洗干净供水管。
6
1206437-T01-A