8881T-VC01
8881T-VC03
K-4904T-ER
、
K-4904T-ET
、
K-4986T-ER
、
K-5016T-YER
、
K-5016T-YET
、
K-18645T-Y-0
8881T-UC01
8881T-UC03
K-4960T-ER
、
K-4960T-ET
、
K-18645T-Y-0
、
K-5016T-YER
、
K-5016T-YET
K-4978T-ER
、
K-4978T-ET
≈
320±40
≈
150
K-4978T-ET
523
≈
320±40
K-4978T-ER
126
149
83
83
126
149
523
Note:
注意：
a.
以上尺寸仅供参考。
b.
出水配件需另行选配。
上进水配管选配
K-2464T-NA,
后进水配管请选用不
锈钢编织软管。
c.
为保证有效冲洗，需配相应冲量要求的小便斗，小
便斗本身需符合
ASME A112.19.2-2003
要求，不推荐
用虹吸式小便斗。
d.
为了保证您能放心使用感应器，当配后进水小便器
时，建议用户自行选配内径不小于
9mm
的不锈钢编织
软管，其接口尺寸分别如图所示。
e.
为保证有效冲洗，推荐供水管路（包括水表、阀等）
内径不小于
25mm
，推荐供水水压（冲洗器进水口流动
水压）：
0.18MPa
～
0.55MPa
。
a. The dimensions above are just for reference.
b. The connection take between the outlet connection
and urinal is not supplied in this package.
Please use K-2464T-NA as top inlet, use stainless
steel hose as rear inlet
c. To ensure an effective flush performance, an urinal
with corresponding flush volume is required. And
the urinal should comply with ASME A112.19.2-2003.
Siphon urinal is not recommended.
d. To insure you can use the sensor with ease, when
used with rear inlet urinal, recommended inner diameter
of stainless steel hose chose by customer is no less
than 9mm.The connection dimensions are shown in the
figures.
e. TO ensure an effective flush performance strongly
recommended inner diameter of water supply (including
water meter, valve, etc.) is no less than 25mm, and
supplied water pressure(sensor inlet dynamic pressure)
is 0.18Mpa~0.55Mpa.
1206437-T01-A
5