Koenic KCB34806-s, Руководство по эксплуатации, Страница: 35 / 97

en
35
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault Possible cause Remedial action
Temperature differs
greatly from the set
value.
In some cases it is adequate
to switch off the appliance
for 5 minutes.
If the temperature is too high wait
a few hours and check whether
the temperature has approached
the set value.
If the temperature is too low check
the temperature again the next day.
Displays
do not illuminate.
Power failure; the fuse
has been switched off;
the mains plug
has not been inserted
properly.
Connect mains plug. Check whether
the power is on, check the fuses.
The temperature
in the refrigerator
compartment is too
cold.
Temperature has been
set too low.
Increase the temperature (see
Selecting the temperature).
Floor of
the refrigerator
compartment is wet.
The condensation
channels or drainage
hole are blocked.
Clean the condensation channels
and the drainage hole. See chapter
Cleaning the appliance. Fig. .
The freezer
compartment has
a thick layer of frost.
Defrost the freezer compartment
(see chapter Defrosting). Always
ensure that the freezer compartment
door is closed properly.