Koehler K244 Sereis, Руководство по эксплуатации и инструкция

Страница: 26 / 46

K244XX Programmable Ashing Furnace
Operation and Instruction Manual
K244XX-Manual
- 22-
Event Control
Events are the “switches” used to turn the digital outputs of the display loop controls on and off. These
events can be manually turned on and off as well as programmed into automatic ramp/soak programs so that
they can be turned on and off at set time intervals.
NOTE: The display loop controls can provide up to 3 event outputs each (for a total of 30 events).
Depending upon the configuration of the display, some outputs may perform specific control or
alarm functions. The use of each output, and what it controls, is determined by the system
designer. If there are questions or concerns about the configuration and operation of your the
display controller, contact your OEM for further information. Only your OEM can address
equipment related issues.
The names of events are also determined by the system designer. The screen shot below is an
example showing factory default event names. Consult section 8.3 on Event Names in order to see
how to change the names of events.
To turn the events on and off, select “Events” from the home “View” menu. Press the switch for each event
that you want to turn on or off to toggle the on/off state of the event. When an automatic ramp/soak program
is running on the loop control that the event is tied to, the event cannot be manually controlled. During
program operation, the event is controlled by the running program. The program must be stopped in order to
control the event manually.
When running a program in the “All” mode, only the events tied to the primary loop are controlled by the
program. All events tied to the individual “slave” loops can be manually controlled.