Koden MDC-7006, Руководство по установке

Страница: 59 / 160

MDC-7000/7900 Series Chapter 3 Installation method
0092669002-07 3-39
3.4.10 Cable connection for inter-switch
3.4.10.1 Cable connection instructions for cross-over, dual and independent
connection
In case of a dual, cross-over, or master/slave connection using two sets of radar system or Display
unit, the remote cable and data cable are connected as shown in the figure 3.23.
(1) The heading, speed and latitude/longitude signals input to the data connector of master Display
unit and are supplied to the slave Display unit via data cable. The slave Display unit can also use
ATA and chart option functions in the same way as the master one.
(2) Connect the slave Scanner unit to the slave Display unit in a crossover connection.
(3) Operation unit (MRO-108) is required for MRD-108.
Figure 3.23 Connecting a slave Display unit on
Crossover, dual and independent connection
Master Display unit
(MRD-108/MRM-108)
J7
Slave Display unit (MRD-108/MRM-108)
Connect slave antenna
unit to slave Display unit in
the case of crossover
connection.
Remote cable
CW-561-10M or 30M
(10m or 30m)
J8
J8
J3
J3
Data cable
CW-373