Chapter 3 installation method
MDC-7000/7900 Series
3-28
0092669002-07
3.3.2 Installation of Operation unit
(1) Remove the corner guard caps of Operation unit. Insert the tip of a small flat-blade screwdriver
carefully between a corner guard cap and the front bezel of Operation unit to make a gap, and then
pinch and pull up the corner guard cap with fingers. Take care not to damage the bezel of
Operation unit by the tip of flat-blade screwdriver.
(2) Remove M4 (4 mm) screws and remove the Operation unit from the mounting bracket.
(3) Mark the place as shown in the following figure, and then secure the mounting bracket with 5M (5
mm) tapping screws at four places.
(4) Secure the Operation unit to clamps with M4 (4 mm) screws that were removed in step (2) and
reinstall the corner caps.
Figure 3.9 Installation of Operation unit
Corner guard cap (4 places)
Operation unit
M4 screw
(4 places)
M5 screw
(4 places)
Clamp (left)
Clamp (right)
Unit : mm(inch)
Содержание MDC-7006
