Koden KSD-1100, Руководство по эксплуатации, Страница: 42 / 98

Chapter 2 Operation and Setting KSD-1100/1210
0093107081-00 2-14
[1] Distance: Distance between two points.
[2] Bearing: Measure the bearing of two adjacent points, that is, the bearing value of the current point
relative to the previous point.
[3] Total distance: The total distance between the measured points will be displayed on the Operation
box.
[4] Operation box: Select [Delete] to delete the current measure point and select [Reset] to clear all the
measure points. Click the [Measure] button to exit the measuring.
2.3.1.4 Center
Click the [Center], in any case, quickly refresh the chart, and display the position of own ship in the
middle of the screen.
2.3.1.5 Track
[1] Click the [Track] to start recording the track, then click again to stop recording the track.
[2] Long press the [Track] to pop up the track new window. Enter the track name, select [Save],
complete the new creation, and start recording. Select [Back] to cancel the track recording.
2.3.1.6 Add Waypoint
On the [CHART] page, long press the position where you want to add waypoints, and the information
window as shown in figure 2.4 (a) will pop up. Click [Add] in the window, and the information editing
window as shown in figure 2.4 (b) will pop up.
Figure 2.4 (a) Add page Figure 2.4 (b) New waypoint page
[1] Click [Confirm] to quickly create a point at this location and enter the data attribute editing window
(as shown in figure 2.5).