Koden KSD-1100, Руководство по эксплуатации, Страница: 37 / 98

KSD-1100/1210 Chapter 2 Operation and Setting
0093107081-00 2-9
2.2.8 Sound
[1] Volume: Equipment volume range 0 to 15.
[2] Touch tone: You can set the button sound on/off.
2.2.9 Notice
You can set the alarm message, short message and AIS message on/off. After the notification message
is closed, the message notification pop-up window will be cancelled, and the message reception and
voice reminder will not be affected. The received message can be viewed in the [SMS] APP.
2.2.10 Advanced settings
2.2.10.1 Custom keys
[FUNC] key functions can be used to set the following items.
Track on or off / Track color switch / Alarm on or off / Chart full screen switch / Screen on or off switch
(A) Track on/off: Press [FUNC] key to quickly turn on or off track record.
(B) Track color switch: When recording a track, press [FUNC] to switch the track color.
(C) Alarm on/off: Press [FUNC] key to quickly turn on or off all set alarms, including sounds and
prompts.
(D) Chart full screen switch: Press [FUNC] to quickly turn on or off the full-screen chart mode.
(E) Screen on/off switch: Press [FUNC] key to turn off the screen or light up the screen.
2.2.10.2 NMEA
You can view signal input and output information. You can select different channels to view input and
output data, set the baud rate of each channel, and configure the NMEA0183_3 port as input or output.
[1] Input
Click [Input] to enter the input signal channel setting page. The details are as follows.
Click the serial port box on the right of [Signal Channel] to select input channels, GNSS&AIS, NMEA
0183_2, NMEA 0183_3, NMEA 0183_4. You can directly check the input sentence on the page.
Note: [NMEA0183_3] is a configurable channel, and input or output can be set in [Advanced Settings] -
[NMEA 0183_3 Configuration], which can be configured as input or output.
Click [Pause] in Signal check out to pause the input sentence screen to view the input sentence. Click
[Reset] to refresh the sentence and re-enter.
[2] Output
Click [Output] to enter the output signal channel setting page. The details are as follows.
(A) If [NMEA0183_3] is set as output, the output page signal channel has NMEA0183_1 and
NMEA0183_3 to choose from.
(B) Click the [Protocol Version] selection box to set the protocol version, including: V2.00 (default),
V3.01, V4.10.
(C) Click the [Checksum] switch to turn the check code of the sentence on or off.
(D) Clicking [Output] will pop up all sentence types. You can set the sentence data on / off, and turn on