Koden CVS-FX2, Руководство по установке, Страница: 66 / 78

Chapter 2 Adjustment CVS-FX2/FX2BB
2-4
0092602002-12
Caution: The setup of beam angle is
reflected on the display of
detecting range and will not
change the actual beam angle.
TD Setting - LF TD2 Setting
1. Press .
2. Select [TD Setting]
– [LF TD2 Setting].
3. Press [ ] of .
The setup box of [LF TD2 Setting] will be
displayed.
4. Set as the same way as [HF TD1 Setting].
5. Press to close the menu.
2.4 Setup of Bottom Limit
If the Bottom Limit is designated, the depth
shallower than the designated water depth is
not detected as sea bottom.
2.4.1 Setup of Bottom Limit HF
TD Setting
–Bottom Limit HF
To set Bottom Limit of high frequency.
1. Press .
2. Select [TD Setting] - [Bottom Limit HF] .
3. Press [ ] of .
The setup box of [Bottom Limit HF] will be
displayed.
4. Press [
▲] and [▼] to set a depth.
5. Press to close the menu.
2.4.2 Setup of Bottom Limit LF
TD Setting
–Bottom Limit LF
To set Bottom Limit of low frequency.
1. Press .
2. Select [TD Setting] - [Bottom Limit LF]
3. Press [ ] of .
The setup box of [Bottom Limit LF] will be
displayed.
4. Press [
▲] and [▼] to set a depth.
5. Press to close the menu.
2.5 Setup of Draft Set
Correct - Draft Set
This is to set the depth between the sea
surface and the depth of transducer instated.
Normally, it is the draft of the boat to be
installed.
(Setting range: except for ft: - 10.0 ~ 10.0, in
ft: - 30.0 ~ 30.0)
1. Press .
2. Select [Correct] - [Draft Set].
3. Press [ ] of .
The setup box of [Draft Set] will be
displayed.
4. Press [
▲] or [▼] to set a draft.
5. Press to close the menu.