Koden CVS-875D, Руководство по установке

Страница: 87 / 122

CVS-875D/877D Chapter 1 Installation
0092607072-01 1-65
Connection table of V104s GPS Compass
Connectors to be
connected
CW-376-5M
Connected to J3
CW-376-5M
Connected to Radar
V104s GPS Compass
cable
No. J3 Color of
cable
Signal of
cable
Color of
cable
Signal of
cable
Color of
cable
Signal of
cable
Port
1 External power
supply (-)
Blue and
shield
GND - - Black PWGND
Port A
2 NMEA2 TX+ White TX+ - - Orange RXA
4 NMEA2 RX+ Orange RX+ - - Violet TXA
6 External power
supply (+)
Green +12V - - Red PWinput
3 NMEA2 TX- Red TX- - -
Brown SigGND
5 NMEA2 RX- Black RX- - -
No. NMEA connector of
Radar
Port B
3 NMEA TX- - Red TX-
5 NMEA RX- - Black RX-
1 NMEA- - Blue and
shield
- - -
2 NMEA TX+ - White TX+ Blue RXB
4 NMEA RX+ - Orange RX+ Green TXB
6 NC - Green - -
Caution: Wind the insulation tape around the un-used lead wire for core-wires not
to contact each other.
2) Connect CW-376-5M to J3 connector of CVS-875D/877D (NMEA terminal with 12V power
supply) after soldering with Port A.
3) Connect CW-376-5M to NMEA terminal of Radar after soldering with Port C when
connecting with Radar as GPS compass. Refer to
“Fig. 1.62 The general connection
chart
4”
.
Connect CW-376-5M to NMEA terminal of Plotter after soldering with Port C when
connecting with the Plotter that can be communicated by 38400bps without Radar. Refer
to
“Fig. 1.63 The general connection chart 5”
.
In the other cases, connection with Port C is not necessary. Refer to
“
Fig. 1.64 The
general connection chart
6”
.
4) Refer to
“Fig. 1.62 The general connection chart 4 to Fig. 1.64 The general connection
chart
6”
, connect other equipment to communicate NMEA with the terminal J8 of
CVS-875D/877D.