Kodak X-OMAT 7000, Руководство пользователя, Страница: 59 / 146

Operating Instructions
7E6174 – 16FEB01 4 –11
Warning
9. To reduce/minimize the possibility of personal injury when moving the Processor
into the Multiloader, the following procedure should be followed.
a. Pull the Processor out approximately 1 cm (0.39 in.) further to release the
tension on the Stop Bracket, and hold the Processor in this position.
b. Push the Stop Bracket to the left side. Place the fingers at the slope of the
Stop Bracket located opposite the tension.
c. Carefully move the Processor in approximately 2 cm (0.79 in.).
Caution
Before moving the Processor any further, move your hands away from the Stop
Bracket. Place both hands into the openings of the left and right Latches on the Front
Cover of the Processor to avoid contact with any moving parts.
d. Carefully push the Processor back into the Multiloader until both Latches
click into position.
10. Connect the Multiloader main power (either the mains plug, grasp the mains plug
only, or move the wall-mounted main switch to the "1" position).
11. Process a test film.
Humidifier Maintenance
If your Multiloader is equipped with a Humidifier, the Humidifier Filter Cartridge
should be changed at least every 6 months, or as needed.
Warning
Only Kodak Service Representative can change the Cartridge.