II 3478
Installation and Set-up Manual
Kodak AG Stuttgart
4/99
3
3 Setup
This section describes how the set-up of the camera is done. It assumes that the operator
is familiar with the camera.
3.1 Getting into setup mode.
Make sure the camera displays the main window which is the window that comes up after
the initial screen with the Kodak and Triacon logo. The window shows:
To get into setup mode now, press Shift F4 (the right soft-key while holding any of the
two shift keys down). A new window will appear asking for a password.
Two passwords are available where one does not give access to all parameters.
The first password LANEX is intended for Kodak personnel. It gives access to all settings.
The other password KELP is intented for Key Operator and will only allow to change the
picture and communication set-up.
Use password LANEX .
Do not give any of these two passwords to the customer.
The KODAK Network ID Camera will remember the password for about 15 minutes and
will not ask you for the password again, if you exit and then enter set-up mode again
within 15 minutes. This is to eliminate the need to re-type the password every time you
leave setup mode to test a configuration.
3.2 Resetting to factory default
Get into configuration mode as described in chapter 3.1. Then press Ctrl-E. This will reset
the memory of the KODAK Network ID Camera and restart the camera just as if you were
switching the power on again. Go to chapter ”Settings” to find out how to change the
language of your preference.
Date: 031197 Time:15:45:48
Selected cassette : Standard, C1
Manual Booking Memory Cass type
