DRY VACUUMING
-6-
1. Make sure that the cloth filter and the sponge filter are on their correct position (see maintenance section).
Make sure both filters are completely dry.
2. Make sure that the head snap clamps are in the closed position.
3. Connect the line cord to a 120 Volts, 60 Hz outlet.
4. Connect the accessory of your choice (except the water suction accessory).
5. Turn the vacuum on using the on / off switch.
6. When finished, turn the vacuum off, disconnect it and wind the cord around the handle.
HOW TO INSTALL THE 28.5" SQUEEGEE
Only for Wet / Dry models
1. Remove the 2 screws (1), the spacers (12) and nuts (11) that are on the squeegee chassis supports
2. Place the flat washers (10), the spacers (2) and the spring loops (3) in the screw (4).
3. Place the squeegee under the chassis and fix it with the flat washer (7) and the nut (8).
4. Align the squeegee chassis supports with the supports on the vacuum cleaner base and place the screws (1)
that were removed on step 1. Place the spacers and nuts in place.
5. Remove the lower handle screw on the right side. And replace using the spacer (5) and the long screw (6) included.
6. Place the spring loop (9) on the spacer.
