7180 Rudder Angle Indicator
Kobelt Manufacturing Co. Ltd.
Rev B
MNL_7180
8 of 24
3
O
PERATION
The 7180 Rudder Angle Indicator system requires no direct user input to function. The system
is passive and responds to signals from a Rudder Feedback Unit or alternative signal sources
such as control levers. The signal commands the needle position on the Indicator. This
position can be calibrated to correspond to physical rudder position or the position of an
alternative signal source.
A single master unit can drive up to 5 slave units. The slave units directly follow the meter
movement of the master. Span configuration is done on the master unit. Zero adjustment is
available on both the master and slave units.
If a backlight dimmer is installed in the system, the operating instructions of the dimmer
manufacturer/installer shall be followed for adjustment of the dimmer.
