7170 Jog Lever
Kobelt Manufacturing Co. Ltd.
Rev B
MNL_7170
20 of 24
12
A
PPENDIX
D:
S
PRING
A
RM
R
EPLACEMENT
It is recommended that any required service work on a Kobelt unit
be performed by a factory authorized service representative. Please
contact the nearest Kobelt authorized distributor for assistance.
If your Jog Lever contains previous generation Spring Arms,
indicated by straight spring arms within the unit, this Retrofit Kit
should be applied to the unit during seal and tension spring
replacement at the next preventative maintenance cycle.
Steps for replacement of spring and seals:
1.
Complete Steps 1-5 of outlined in Appendix C: Repair Kit Installation.
2.
Discard old spring arms and spring.
3.
Slide bushing onto new spring.
4.
Attach spring (with bushing) to spring arms.
5.
Slide spacer onto shaft assembly (before spring arms).
6.
Reassemble unit as per Step 11 of Appendix C: Repair Kit Installation.
Figure 9: 7170 Spring Arm Order
