kobalttools.com
13
ASSEMBLY INSTRUCTIONS
N
L
5
5. Replacing the line
a. If necessary, remove any old trimmer line from
the cutting head. See the Removing old trimmer
line section on Page 14.
b. Turn the spool cap (N) until the slots on the
spool cap and spool cover (L) are aligned.
Slots
c. Cut 15 ft. of new 0.080 in. monofilament trimmer
line.
d. Insert the trimmer line into the eyelet. Push the
trimmer line until a few inches protrude from the
other eyelet.
e. Pull the trimmer line through until the ends are of
equal length.
Eyelet
f.
Turn the spool cap (N) clockwise to wind the line
until about 5 in. extend from each side of the
spool.
N
