Scene control
Parameter name
Values
Scene operation
Recall scene
/ Save scene
Scene number
1
... 64
Scene type
External
/ Internal
If the “Scene control” action is selected, a specific scene will be recalled or saved when the
action is triggered, depending on the
Scene operation
parameter. The
Scene number
and
Scene
type
parameter select the scene that will be affected by this operation.
3.6.3
Binary - Switch
Parameter name
Values
Action when contact CLOSES
None
/ Send 0 / Send 1 / Toggle 0/1
Action when contact OPENS
Same options as for Action when contact
CLOSES
Evaluate initial state
No
/ Yes
Enable locking object
[Checkbox]
Binary inputs in switch/sensor mode can trigger actions when the state of the input changes.
A different action (send 0, send 1, or toggle between 0 and 1) can be associated to each state
(
Action when contact CLOSES
and
Action when contact OPENS
).
Additionally, the
Evaluate initial state
parameter determines whether the state of the input
should be evaluated (and the corresponding action triggered) at application startup time, and
also after bus voltage recovery.
The
Enable locking object
checkbox enables an additional communication object that can be
used to lock operation of this input. While the input is locked, any changes in the input state
are ignored, and no actions are triggered.
3.6
Inputs
93
