Contents
• KeySecure 6
• Security screw wrench for technician access lock (
tech-lock
)
• Wiring pigtail crimp connectors and heat shrink
• WiFi antenna
• 3V Lithium coin cell battery
• USB cable
Tools Required
• 1/16" Allen wrench
• 5/32" Allen wrench
• Hand crimper
Bracket Mounts
(optional)
• 60˚ or 90˚ bracket (
sold separately
)
• Flat-mount bracket (sold separately)
NOTE:
See instructions shipped with your specific bracket for
additional details, or access the technical documentation in
the FD Portal at KnoxBox.com.
Getting Started
1. Ensure vehicle and KeySecure are powered down before beginning
installation, and observe safe practices when working with power and
electrical components.
2.
IMPORTANT: The Keysecure 6 requires continuous power to charge the
Knox eKey. Do not use a power source controlled by the ignition switch.
3. Use min 18AWG to connect device to power.
4. KeySecure 6K-2 requires 7A @ 12VDC max power or use
Model
KSM-200AC AC/DC
transformer with a 120VAC wall outlet.
5. Do not insert keys until the KeySecure 6 is powered. The mechanical
key will be locked in place until power and a valid PIN code is used.
Installation Instructions
1. Remove technician access lock
(tech-lock)
:
a. Using security screw wrench, remove two security screws
from tech-lock cover by turning counterclockwise
b. Remove tech-lock cover plate
c. Insert tech-key into tech-lock and turn counterclockwise
until lock is loosened and remove lock
2. Using 5/32” Allen wrench, remove two mounting bolts on
either side of unit by turning counterclockwise.
3. Rotate bottom out, then lift unit up and off of the back cover.
NOTE:
Back cover should easily remove. Do not force.
If needed, call technical support for assistance.
4. Install Battery
(Battery included with shipment)
:
a. On back of unit, locate the battery socket in the upper
right corner beneath the black insulator shield
NOTE:
To remove old battery, use a 1/16” Allen wrench to move
the battery down and out of the battery socket.
KEYSECURE® 6
QUICK START INSTALLATION GUIDE
1
2
3
4
5
Mounting
bolt
Mounting
bolt
Technician
lock (tech-lock)
cover
1601 W. DEER VALLEY RD. PHOENIX, AZ 85027 |
T.
800-552-5669 |
F.
623-687-2290 | [email protected] |
KNOXBOX.COM
OPE-ESYSLR-0326-H
©Knox Company. All rights reserved.