IR210
IR210 Infrared Receiver Specifications:
J-box Infrared Receiver
Specifications
Installation Instructions
v1.2
Infrared carrier frequency: 30-60kHz
Indoor reception range:
20-25 feet (6-8 meters)
Warning
: To be installed and/or used in accordance with
appropriate electrical codes and regulations.
Outdoor reception range:
Not recommended for outdoor use.
Nominal reception angle: 50 degrees off axis
Maximum wire length:
1000’ (300m) or more with larger
gauge wire
Introduction:
Thank you for your purchase of a Knoll IR210
infrared receiver. This receiver features the ability to pick up a
remote control infrared signal and relay it on wires to another
location up to 1000’ (or more).
Wire requirements:
3 conductors, minimum 24-gauge
to 200’; 22-gauge up to 500’;
20-gauge to 1000’
Power requirements:
Unregulated 12VDC, 40mA
Dimensions:
1-3/4" x 4" x 1"
Features:
(45mm x 102mm x 26mm)
•
Inwall junction box design
available in white, ivory, almond
and black colors.
System
power
on LED
IR
Receiver
Blue
talkback
LED
Requires 12VDC power supply, emitter(s) and IR54, or
IR55 connection block.
•
Will relay almost all remote
types (except some B & O
models).
control
st
)
Warranty
•
Can be connected with almost any
3-conductor wire including cat 5.
Sugge
Knoll Systems warrants its products sold in the USA and Canada by authorized
Knoll dealers to be free of defects in materials and workmanship. This warranty
extends for three full years from the date of purchase by the original consumer.
Any products returned to Knoll Systems and found to be defective by Knoll
Systems within the warranty period will be repaired or replaced at Knoll Systems
option, at no charge. Knoll Systems will not be responsible for the actual cost of
installation or removal of the product, nor for any incidental or consequential
damages. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you. This
warranty gives you specific legal rights. You may have additional legal rights
that vary from state-to-state.
•
Requires very little power.
using PS1202 12 VDC (200 mA
for up to 5 IR210s.
•
Up to 10 IR10’s, IR210’s and other
compatible models can be
connected in a single system.
•
Connects with a three wire
connector or RJ45 via cat 5 wire
Installation Tips
1. Follow all local electrical & building code requirements.
2. The IR210 is usually wall mounted. It does not normally
require a junction box. For easy installation and to ensure
reliability, it is suggested that a PS1202 (200 mA) or PS1205
(500 mA) 12 VDC unregulated power supply, IR31 (single) or
IR34 (dual) emitters and one of the following: IR54 (decora
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
12140 Horseshoe Way, Richmond BC V7A 4V5
Telephone: (604) 272-4555, Fax: (604) 272-5595
Made in Canada Knoll Systems All Rights Reserved
