22
Installing the Sensor
Ceramat® WA 160(X) Retractable Fitting
Installing the Sensor
First, remove drive unit (page 19)
1) Use appropriate sensors
(C)
only:
Diameter: 12-0.5 mm Length: 225 mm
Observe the pressure resistance of the sensor.
2) Check whether slide ring
(A)
or O-ring
(B)
on the
sensor are damaged.
A
B
C
D
3) Bend the sensor end
(D)
in direction of the
arrow (until it noticeably snaps in).
This gives access to the sensor coupling.
