31
Figure 7-4
Replacing the wet-grinding belt
Figure 7-5
Replacing the wet-grinding belt
Figure 7-6
“Reset belt runtime?” message
7.2 Changing the wet-grinding belt
After a predefined time, the message (3-6/1)
“Replacing grinding belt” appears at the top of
the touchpanel.
Press “Replace belt” (3-6/23) on the touchpanel.
The gripper (7-4/1) grabs the belt protection
hood (7-4/2) and places it on the right side. The
wet-grinding belts (7-5/1) are released automati-
cally.
Remove the old grinding belts (7-5/1) and then
attach the new ones.
Press the “Replace belt” touchpanel button
(3-6/23) again in order to have the gripper close
the belt protection hood.
The grinding belts are tightened automatically.
NOTICE
The wet-grinding belt is subject to uneven
wear. Therefore, we recommend rotating the
belt once before replacing it with another.
When closing the belt protection hood, the mes-
sage “Reset belt runtime?” appears on the main
screen.
Answer the question with “Yes” (7-6/1), if the
grinding belt has been replaced or rotated.
If the belt protection hood was only opened to
assess the grinding belts, answer the question
with “No” (7-6/2).
7. Operation
1
2
1
1
1
2
