41
Operation
BlueShadow Pump 80P Instructions V7685
5.8.6 Create a program with a starting time
The pump can start a program at a preset time (
Wake Up program). The
pump starts the selected program at the specified time and date. The
display switches from standby to run mode.
Process
Figure
1.
Select the menu
Program.
2.
Enter program number 20.
3.
Enter the time, date and program number you
wish to start by navigation with the horizontal
keys and activate the numeric pad by
pressing .
4.
To run the
Wake Up program follow the pro-
cedure as if running any other program. Upon
choosing program 20 the pump will go into
standby until the set wake up time and date.
5.9 Link menu
The
Link menu displays the status of active links. A maximum of ten pro-
gram links between defined programs can be created and saved.
Navigate Link menu
1.
Open the desired link number.
2.
Use the horizontal arrow keys to navigate through the two lines
of the display.
3.
To change a value use the vertical arrow keys or press and
change the value by the numeric pad.
4.
Move the cursor to the double arrow on the lower left line to navigate
to the next line or create a new line.
5.9.1 Create link
Process
Figure
1.
Select the
Link menu.
2.
Enter the link number.
3.
Press to enter the editing mode of the link.
4.
Move the cursor to position P in the display and
enter the program number you wish to run.
5.
Move the cursor to position R (Repeat) and en-
ter the number of repetitions for the specified
program.
6.
Move the cursor to position W in the display
and enter 1 or 0.
Note:
If W1 (W = Wait) is used, the pump waits for an external start signal
or for the user to press the upward key to set the status to run before exe-
cuting this line. If the W0 setting is used, the link sequence runs without
interruption.
Procedure
