Knauer BlueShadow 80P, Инструкция по эксплуатации

Страница: 31 / 74

25 Installation
BlueShadow Pump 80P Instructions V7685
4.5.5 Configuring the LAN settings
The LAN uses only one server (which is normally the router) from that the
devices automatically receive their IP address.
ƒ
In Windows, power saving, hibernation, standby, and screen saver
must be deactived.
ƒ
In case you use an USB-to-COM box, the option “Allow the computer
to turn off ths device to save power” in the devicemanager must be
deactivated for all USB hosts.
ƒ
Applies to all LAN devices: Disable the setting for the network adapter
in Device Manager “Allow the computer to turn off this device to save
power”.
1. In Windows choose Start > Control Panel > Network and Sharing
Center.
2. Double-click on LAN connection.
3. Click on the button Properties.
4.
Select Internet Protocol version 4 (TCP/IPv4).
5. Click on the button Properties.
6. Check the settings in the tab General. The correct settings for the
DHCP client are:a) Obtain an IP address automatically) Obtain DNS
server address automatically.
7. Click on the button OK.
4.5.6 Connect devices to LAN
A router
3
has several LAN ports
2
and one WAN port
4
that can be
used to integrate the LAN into a wide area network (WAN), e.g. a com-
pany network or the Internet. In contrast, the LAN ports serve to set up
a network from devices
1
and a computer
5
. To avoid interference, we
recommend operating the chromatography system separately from the
company network.
1 2 3
4
5
You will find patch cables for each device and the router in the acces-
sories kit. To connect the router to a LAN, an additional patch cable is
required, which is not supplied within the scope of delivery.
ƒ
The computer has been switched off.
ƒ
There is a patch cable for each device and the computer.
Prerequisites
Procedure
Prerequisites