20
Installation and initial startup
BlueShadow Pump 40P Instructions V7613
Note:
You will find patch cables for each device and the router in the
accessories kit. To connect the router to a LAN, an additional patch cable
is required, which is not supplied within the scope of delivery.
1
Devices
2
Router
3
LAN ports
4
WAN/Internet
connection
5
Computer
1
2
3
4
5
Fig. 10:
Connect devices with LAN
The computer is switched off.
There is a patch cable for each device and the computer.
Process
1.
Use the patch cable to connect the router and the computer.
Repeat this step to connect all devices.
2.
With additional patch cables, connect all devices individually with
the router.
3.
Use the power supply to connect the router to the mains power
system.
Set the router properties (see chapter 4.6.4 on page 20).
4.6.4 Configuring the router
The router is preset at the factory. Information about address, user name
and password is noted in the router manual:
www.knauer.net/router
.
Process
1.
To open the router configuration, start your Internet browser and
enter the IP address (does not apply for all routers).
2.
Enter user name and password.
3.
Configure the router as DHCP server.
4.
In the router configuration, check the IP address range and make
changes if necessary.
Note:
If the IP address range has been changed, it is essential to note
this information on the router.
Once the router has assigned IP addresses to all devices, the chromato-
graphy software can be used to remotely control the system.
Prerequisites
Procedure
Next steps
Procedure
Result