28
Removing and maintaining the pump drive
Removing the drive shaft
Removing the slide
Result
The movable parts in the pump drive were checked, greased and,
if necessary, replaced.
Next steps
Assemble the pump drive and install as described above.
Process
Figure
1. Remove drive shaft.
2. Check drive shaft for
signs of wear.
3. Replace drive shaft if
necessary.
4. Grease the cam pla-
tes on the drive shaft
with Molykote gre-
ase paste.
Fig. 32
Drive shaft with gearwheel
Process
Figure
1. Remove slider (A) on
both sides of the
drive.
2. Check slider for signs
of wear.
3. Replace slider if
necessary.
4. Grease the ball bea-
rings of the slides
with Molykote gre-
ase paste.
5. Grease the surfaces
of the sliders with
Molykote bearing
grease.
Fig. 33
Slider in the drive
Fig. 34
Slider with cover plate
A
A
