Knauer Azura P 2.1L, Руководство пользователя

Страница: 22 / 44

P 2.1L user manual V6840, version 3.6
Installation 19
5. Click on the button Properties .
6. Check the settings in the tab
General
. The correct settings for the
DHCP client are:
a)
Obtain IP address automatically
b) Obtain DNS server address automatically
7. Click on the button
OK
.
Connecting the cables
A router
2
has several LAN ports
3
and one WAN port
4
that can be
used to integrate the LAN into a wide area network (WAN), e.g. a com-
pany network or the Internet. In contrast, the LAN ports serve to set up a
network from devices
1
and a computer
5
. To avoid interference, we
recommend operating the HPLC system separately from the company
network.
You will find patch cables for each device and the router in the accessories
kit. To connect the router to a WAN, an additional patch cable is required,
which is not supplied within the scope of delivery.
Prerequisites

The computer has been switched off.

There is a patch cable for each device and the computer.
Process 1. Use the patch cable to connect the router and the computer. Repeat
this step to connect all devices.
2. Use the power supply to connect the router to the mains power system.
Configuring the router
The router is preset at the factory.
You find information about IP address,
user name and password in the router instructions: https://goo.gl/
ahGhmG .
Process 1. To open the router configuration, start your Internet browser and enter
the IP address (not for all routers).
2. Enter user name and password.
3. Configure the router as DHCP server.
4. In the router configuration, check the IP address range and make
changes if necessary.
Note: If the IP address range has been changed, it is necessary to note it
down.
Result Once the router has assigned IP addresses to all devices, the chromatog-
raphy software can be used to remotely control the system.
Integrating the LAN into a company network
A network administrator can integrate the LAN into your company net-
work. In this case you use the WAN port of the router.
Prerequisite

There is a patch cable for the connection.
Process 1. Check that the IP address range of the router and of the company net-
work do not overlap.
1 2 3
4 5