Knauer Azura DAD 2.1L, Инструкция по эксплуатации

Страница: 37 / 81

31 Operation
AZURA® Detector DAD 6.1L, DAD 2.1L, MWD 2.1L Instructions, V6700
The LEDs can have different colors depending on the operating
condi tions.
To start the standby, keep the standby button pressed for 5 seconds.
Note: Malfunctioning system after repeated standby possible. After repe-
atedly using standby, restart the device using the power switch to reset
the device‘s data storage.
Color Status
ƒ
Operation
Left LED red Error
ƒ
Check the system.
ƒ
Shortly press the
switch to deacti-
vate the error
mes sage.
green 3D data are acquired.
Center LED does not light The lamp has been
switched off.
flashes green The lamp/lamps are
initializing or the vali-
dation is progressing.
ƒ
Wait until the
lamp is running or
the validation is
finis hed.
green The deuterium lamp
is active.
Right LED green The device has been
switched on.
flashes green The device not ready
for operation.
ƒ
Wait until the
device is ready for
operation.
blue The device is in
standby
ƒ
Press the standby
button to end the
standby.
5.5 Default settings
Using the Mobile Control, you can reset the detector to its default
set tings.
Parameter Setting
Network LAN DHCP, port 10001
Lamps Deuterium ON, Halogen OFF (DAD 6.1L only)
Time constant 2 s
Channels Channel 1: WL = 254 nm, BW = 8 nm
Reference
correc tion
Reference channel enabled for channel 2,
WL = 360 nm, BW = 30 nm
Standby