AZURA® Assistant ASM 2.2L Instructions V6803
24
Initial startup
7.
Click on the button
OK
.
8.2.2
Connecting the cables
A router
3
has several LAN ports
2
and one WAN port
4
that can be
used to integrate the LAN into a wide area network (WAN), e.g. a compa-
ny network or the Internet. In contrast, the LAN ports serve to set up a
network from devices
1
and a computer
5
. To avoid interference, we
recommend operating the chromatography system separately from the
company network.
You will find patch cables for each device and the router in the acces-
sories kit. To connect the router to a WAN, an additional patch cable is
required, which is not supplied within the scope of delivery.
The computer has been switched off.
There is a patch cable for each device and the computer.
1.
Use the patch cable to connect the router and the computer. Repeat
this step to connect all devices.
2.
Use the power supply to connect the router to the mains power sys-
tem.
8.2.3
Configuring the router
The router is preset at the factory. Informationen zu IP-Adresse, Benutzer-
name und Passwort finden Sie im Handbuch des Routers:
www.knauer.net/en/Support/User-manuals/PC-hardware
.
1.
To open the router configuration, start your Internet browser and enter
the IP address (not for all routers).
2.
Enter user name and password.
3.
Configure the router as DHCP server.
4.
In the router configuration, check the IP address range and make
changes if necessary.
Note:
If the IP address range has been changed, it is necessary to note it
down.
Once the router has assigned IP addresses to all devices, the chromatog-
raphy software can be used to remotely control the system.
8.2.4
Integrating the LAN into the company network
A network administrator can integrate the LAN into your company net-
work. In this case you use the WAN port of the router.
There is a patch cable for the connection.
1.
Check that the IP address range of the router and of the company net-
work do not overlap.
1
2
3
4
5
Prerequisites
Procedure
Procedure
Result
Prerequisites
Procedure