TOP & BOTTOM MOUNTING
WIRE FULL ROUND LAZY SUSAN
Installation Instructions
RN263EFS_B_Tp&BtmMntLzSusn_0213
© 2013 Knape & Vogt Manufacturing Company. All rights reserved.
Inspect all parts and read all instructions prior to beginning assembly and installation.
Step 1
To locate the unit inside your cabinet,
place a shelf on the post and position
it inside the cabinet so the door can
close without interference. Mark all
screw hole locations on the cabinet
floor. Remove the post and shelf from
the cabinet. Drill pilot holes for
fastening screws, and attach the post
to the cabinet floor using the screws
provided.
Step 2
Assemble the shaft collars by placing
T-nuts through holes and inserting
setscrew into T-nut. Turn screw 2 or 3
times to engage. It will be tightened
later. Place one of the shaft collars
(slotted side up) at the desired height
for the lower shelf and tighten
setscrews finger-tight to hold in
place. Tighten the setscrew on the
collar and close the door to check for
clearance.
Step 3
Place the remaining shaft
collar(s) (slotted side up) on
the post and repeat the
installation instructions
above. Insert the top mount
support in the top of the
post. Lift the top mount
support up towards the top
of the cabinet and secure it
in place using screws and
washers provided.
Installation is now
complete.
Parts Included
A. (2) Shelves
B. Post
C. (2) Shaft collars
D. (4) setscrews
E. (4) T-nuts
F. Top Mount Support
G. Mounting screws
Tools Required
• Phillips head screwdriver
• Drill with 1/16” (1.5mm) bit for
drilling pilot holes
• Pencil
Product Assemblies
FR18S3TM
FR20S3TM
FR24STM
FR28STM
FR32STM
A
B
E
G
step 1
step 2
step 3
F
G
F
C
D
KNAPE & VOGT MANUFACTURING COMPANY
2700 Oak Industrial Drive NE • Grand Rapids, MI 49505
800.253.1561 • www.kv.com
