background image

22-1/4” (562mm)

15-1/2” (394mm)

KD-50: Economy Keyboard Tray

INSTALLATION GUIDE

Important!

Protect your eyes - wear safety goggles during installation. This unit is only meant for computer keyboard
storage and is not capable of supporting human weight.

Installation Instructions:

1. Remove keyboard tray mounting components from inside keyboard tray (A) in the  enclosed plastic bag.
2. Identify the drawer slides (C) and remove the outer detachable slide member of the left drawer slide by

pressing the spring clip. See Figure 1.

3. With a Phillips screwdriver, attach 2 mounting brackets (B) to each of the drawer slide outer members

using 4 short drawer slide screws (D). See figure 2. You may attach the mounting brackets to either the
top or bottom row of holes depending on your keyboard tray height preference.
Use 2 drawer slides screws (D) and 2 drawer slide nuts (E) to attach each bracket. The brackets are easiest
to install if the top bend is facing out. NOTE: The screws must be installed as illustrated in Figure 2 in
order for the slides to have full movement. 

4. Attach the inner drawer slide member with the spring clip to the

keyboard tray with 2 long drawer slide screws (D) and 2 drawer slide
nuts (E). See Figure 3.

5. Repeat Steps 1 to 4 to attach the right drawer slide.
6. Attach keyboard tray with inner slide member to outer slide member

and brackets. See Figure 4.

7. Hold the keyboard tray in place under your work surface. Using a pen

or pencil, mark the location of the 12 screw holes. See Figure 5.

8. Drill 1/8” diameter starter holes at the screw locations. See Figure 6.

NOTE: Do not drill through the top of the desk.

9. With a Phillips screwdriver, attach the keyboard tray brackets to the

underside of the desktop. Use 3 desktop screws (E) per bracket, as
shown in Figure 7.

Tools Required

1

Drill

1

1/8" Drill Bit

1

Phillips Screwdriver

General Parts

1

Keyboard Tray (A)

1

4 Mounting Brackets (B)

1

Tray Slide Pack (C)

1

Hardware Pack:
- 12 drawer slide screws (D)

(4 long & 8 short) 

- 12 drawer slide nuts (E)
- 12 desktop screws (F)

Knape & Vogt Manufacturing Company

2700 Oak Industrial Drive NE

Grand Rapids, MI 49505

888.253.1561 • 616.459.3311

fax 888.459.3290 • www.kv.com

Rev:1103

PULL

PUSH

A

B

C

D

drawer 

slide 

screws

desktop 

screws

drawer 

slide 

nuts

E

F

inner drawer

slide member

outer drawer

slide member

1

A

A

A

A

A

2

3

4

5

6

7

Отзывы: