Step 1
Install the three rollers onto the
base of the unit into the pre-
threaded holes as shown in
Figure 1. (Note the installation of
the spacer on Roller C). The
rollers must be installed on the
same side of the unit as the upper
roller at the top of the unit. Use
the provided Allen Wrench to
tighten rollers securely in place.
Bottom slides must be in the
extended position prior to installing
the 3 rollers.
Step 2
With the unit in the closed position
(Figure 2), place the sliding blind
corner unit on the cabinet floor
against the back edge of the cabinet
face frame and 1” from the side of
the cabinet opening. (If installing in a
frameless cabinet, position unit 3/4”
back from the cabinet opening). The
sliding frame must be orientated so
that the pull-out knobs face forward
to the cabinet opening.
To verify the assembled unit will properly clear
the door opening and adjacent cabinet doors,
temporarily place the baskets on the sliding
frame and carefully hold unit in place while
sliding it out so both shelves extend out of
the cabinet.
Step 3
Once final position and proper clearance has
been determined, remove the baskets and
mark pilot hole locations for fastening the
sliding frame to the base of the cabinet. Drill
pilot holes and fasten with 6 mounting screws (provided) thru the mounting
brackets
(Figure 3).
Step 4
Once unit is securely fastened in the cabinet, place the baskets in the desired
position and confirm that the unit clears the cabinet opening and adjacent
cabinets.
Installation is now complete.
Parts List
A. Sliding Assembly
B. 4 Wood/Wire Baskets
C. 6 Mounting screws
D. Allen Wrench
Tools Required
• Phillips head screw driver
• Tape measure
• Pencil
• Drill with 1/16” bit for drilling pilot
holes (optional)
Product Assemblies
BBCT-L-15
BBCT-R-15
BBCS-L-15
BBCS-R-15
SLIDE-OUT BASE BLIND
CORNER UNIT
Installation Instructions
KNAPE & VOGT MANUFACTURING COMPANY
6625 N. Old State Rd. 3 • Muncie, IN 47303
800.899.6535 • 765.288.8730 • Fax 765.288.1567 • www.kv.com
RN-276EFS/0504
© 2004 Knape & Vogt Manufacturing Company. All rights reserved.
Inspect all parts and read all instructions prior to beginning assembly and installation.
Part Minimum Cabinet
Number
Door Opening
Description
BBCT-L-15
15”W x 27”H
45” – 48” base left blind corner w/tall door
BBCT-R-15
15”W x 27”H
45” – 48” base right blind corner w/tall door
BBCS-L-15
15”W x 20”H
45” – 48” base left blind corner w/std. door
BBCS-R-15
15”W x 20”H
45” – 48” base right blind corner w/std. door
VIEW FROM ABOVE
VISTA DESDE ARRIBA
VUE DU DESSUS
RIGHT Blind Corner
Esquina ciega DERECHA
Côté borgne À DROITE
LEFT Blind Corner
Esquina ciega IZQUIERDA
Côté borgne À GAUCHE
1
2
3
