MEP-7xxx Direct-Coupled Actuators (up to 320 in-lb.)
4
Applications Guide, AN1113A Rev. D
Models
Powered Timing (Full Rotation)
MEP-72xx
75–90 seconds,
load dependent
MEP-75xx
90–115 sec., load
dependent
Fail-Safe Timing (Full Rotation)
MEP-725x
65–100 sec., load
dependent
MEP-755x
80–115 sec., load
dependent
*NOTE:
The
MEP-7200
series (120 in-lb.) has been
discontinued. Use an MEP-75xx (180
in-lb.)—or, if less torque is required, an
MEP-48xx (80 in-lb., non-fail-safe) or MEP-
49xx (90 in-lb., fail-safe) instead. Besides
maximum torque, the differences between
the MEP-7200 and MEP-7500 series include:
Model #
Torque
Control
Built-in Options
180 in-lb.
(20 N•m)
min.
320 in-lb.
(36 N•m)
min.
Tri-state
(Floating)
0–10 VDC, 2–10
VDC, or 4–20 mA
Proportional
Feedback:
10K ohm
Potentiometer
Feedback:
0/1–5 or
0/2–10 VDC
Fail Safe
MEP-7x01
7500 series
(x=5)
7800 series
(x=8)
4
MEP-7x02
4
4
MEP-7x03
4
4
MEP-7x51
4
4
MEP-7x52
4
4
4
MEP-7x53
4
4
4
The MEP-72xx series (120 in-lb.) has been discontinued. Use the MEP-75xx series (180 in-lb.)—or, if less torque is required, an MEP-48xx (80
in-lb., non-fail-safe) or MEP-49xx (90 in-lb., fail-safe) instead.
To replace the MEP-70xx series (150 in-lb.), use MEP-75xx series (180 in-lb.).
To replace the MEP-77xx series (300 in-lb.), use MEP-78xx series (320 in-lb.).
NOTE:
See also the
.
NOTE:
Before Jan. 2014,
MEP-7xx2 proportional
models had (besides the 4-20 mA input)
a
0–10 VDC input
and
0–5 or 0–10 VDC
feedback
. From 2014 through July 2015,
they had a
2–10
VDC input and
1–5 or 2–10
VDC feedback instead. Starting in August
2015,
all
these options were available and
selectable via a jumper and slide switch.
NOTE:
When the
0
–10 VDC input is selected (with
the jumper), selectable (with a switch)
feedback options are
0
–5 or
0
–10 VDC.
When the
2
–10 VDC input is selected,
feedback options are
1
–5 or
2
–10 VDC.
