Klugmann KT905X, Инструкция по эксплуатации

Страница: 9 / 12

BLUE
YELLOW - GREEN
BROWN
e) 2 electrical appliances should not be connected to the same wall
outlet at the same time;
f) if the power cable will be replaced, H05VV-F type 3xl,5mm
2
cable
should be used;
g) it is essential that the support poles of the empty terminals be
distinguished (Brown=Phase Blue=Neutral Yellow/Green=Earth).
NOTE : Check that the values of your mains connection (voltage,
maximum power and current) comply with the features of your
hob.
Replacing the injectors
NOTE: These products are already set to operate with LPG (G 0) at the factory. Replace the injectors as
specified below in case a different type of gas is used:
1. Remove the pan support and the burners;
2. Remove the injectors by removing their screws and then install new injectors which are procured in
accordance with the gas type in use and make sure that their brand matches with the one prescribed in the
list
.
3. Install the burners and the pan support;
4. No air adjustment is required for these burners.
Warning
If the gas type of the appliance is converted to another type, it is necessary to affix the adhesive label, which
was supplied as accessory, onto the plate. When it is operated with LPG gas
(G30),
the adjustment screw
should be turned to the end. These appliances are supplied as II 2H3+ category.
Minimum adjustment
- Remove the knobs (they can be removed since they were mounted by being pressed on).
- Ignite the burners and turn the adjustment screw to clockwise to decrease the flame, and turn it
counterclockwise to increase the flame. (Figure 3) You can make the adjustment with a screwdriver.
To decrease or increase the flame in the
burners, you can adjust them by turning
the screws.
Figure 3