KLS Martin CEMOR, Инструкция по монтажу

Страница: 78 / 84

Mounting Instructions
0B
CEMOR Monitor Suspension System
78 Revision 1
19.2.1 General Technical Data
Designation All suspension arm systems
Operating mode suitable for continuous operation
Activation time of the electromagnetic brakes max. 1 min*
Rating plate
The rating plate is located on the upper
extension arm, see section 4.1 “Information on
the Rating Plate”, page 25.
Electrical data
Nominal voltage 120–230 VAC
Nominal frequency 60/50 Hz
Max. load on the terminal 10 A
Max. cable cross-section on the terminal
(depending on the customer-specific
configuration)
4 mm
2
Sound pressure level
A level of 65 db(A) (EN ISO 3746) is not
exceeded
Manual forces
see Instructions For Use of the suspension arm
system
Protection class acc. to IEC 60601-1 I
IP classification as per IEC 60529 IP 20
Approvals of the standard design Recognized NRTL component
Ambient conditions
Storage and transportation
-25°C to +70°C (-13°F to +158°F) at 10–75%
humidity (relative) and air pressure 500–
1,060 hPa
Operation
+10°C to +40°C (+50°F to +104°F) at 30–75%
humidity (relative) and air pressure 700–
1,060 hPa
(corresponds to a maximum operating altitude
of 3,000 m)
Conformity to standards
see section 3.5 “Standards and Guidelines”,
page 23
Medical Device Directive 93/42/EWG Classification I
Permissible adaptions
see section 20 “Permissible Third-Party
Adaptions”, page 79
* If the electromagnetic brakes are actuated for a longer time, the power supply unit can switch off
automatically to prevent overheating.
If the power supply unit has switched off, then it must cool down for 10 min before it can be switched
on again, and must then be disconnected from the building
’
s power supply for 10 seconds.
Only then can the standard operation of the system be resumed.