KLING & FREITAG VIDA M Adapter Plate, Руководство пользователя

Страница: 8 / 16

Page 8 of
15 Version 1.0 © KLING & FREITAG GMBH
User's Manual
VIDA M Adapter Plate 1.0 23.10.2020 10/23/2020
K&F VIDA M Adapter Plate
3 Safety Instructions
3.1 General Safety Instructions
3.2 Safety Instructions When Mounting the System as a
Stand
The information described here does not relieve the user of the duty to follow the given safety
requirements and legal regulations.
The technicians responsible for installing the system on site are responsible for and guarantee
safe setup and use. They must be qualified event technicians and use appropriate personal pro-
tective equipment at all times.
To prevent injury and damage, be sure to securely place the speaker system as specified in the
DGUV regulations 17 (BGV C1) or similar locally applicable accident-control standards.
WARNUNG
Risks imposed by falling or overturning parts.
Adjust the base plate appropriately, so that the stand is exactly vertical.
Always follow the technical documentation and the structural certifications on the following
web page: https://www.h-of.de/en/products/designstand/designstand-d-line/2222/excellent-
line-designstand-d4.
Accessories are not designed for frequent mounting to/unmounting from the speaker. Be sure
to mount the accessories to a speaker no more than five times during the overall product life-
cycle. Therefore, you might want to mount the accessory to an Excellent Line DesignStand Uni-
versal Header HD and leave the Universal Header HD permanently attached on the speaker.
Be sure to tighten all bolts and screws to the specified torque.
Unless otherwise stated, use only KLING & FREITAG original parts for mounting the speakers.
Never use other parts (in particular, parts not made by KLING & FREITAG).
Be sure to always visually inspect all accessories and loudspeakers before use. In fixed installa-
tions, regularly check all system components for signs of wear. Visual inspection includes
checking the system components of the speakers as well as the mounting components. During
the inspection, check all mounting components carefully for deformations, cracks, bolt dam-
age, and corrosion. If there are signs of wear, cracks, or deformation, etc., replace the affected
parts immediately.
See also the »Maintenance« chapter on page 15.
WARNUNG
Never place stands on emergency escape routes.
For any application, always have a proof of stability issued.
This can be done on the basis of the structural analysis available on the manufacturer's website
at: https://www.h-of.de/media/pdf/b1/e5/3d/ELD4_Statik.pdf.
The proof of stability must be issued by a qualified event technician or a structural engineer.
Remember that placing speakers onto or removing them from speaker-stands poses specific
risks. Be sure to use means suitable for the purpose (for example, lifts or platforms).
If you put up the stand in a public area, establish a minimum height of 1.6 meters (5¼’) from
the floor to the bottom edge of the speaker.
Be sure not to place more than one VIDA M speaker upright on the adapter plate.