20
www.klindex.com - Made in Italy
ELECTRICAL CONNECTIONS
6 Electrical connections
l
NOTICE
Before performing any operation on the
appliance, make sure that the main dial is
set to “OFF”.
6.1 Connecting to the power socket
l
WARNINGS
– Before connecting the appliance to the
mains power network, make sure that
the voltage and frequency are suitable
for appliance operation as indicated in
the section "
Technical characteristics"
on page 45.
– The power socket must be earthed.
To connect the appliance to the mains power socket,
simply insert the plug (1) into a suitable 32 amp power
socket and tighten the ring nut.
It is recommended that electrical power cables type
H07RN8-F QUADRUPOLE are used: cable 4G6, length
MAX 50 m (165 ft).
d
NO
Cutting or altering the plug and using
adapters. Only a qualified and authorised
electrician can replace the plug, if neces-
sary. Only a qualified electrician can re-
place a burned, cut or damaged electrical
cable.
l
WARNINGS
– Before moving the appliance to the
work area, make sure that the handle
grip and caster wheel are both inserted
and locked.
– The planetary must be fully raised from
the floor: act on the joystick to raise/
lower the planetary.
6.2 Adjusting the electrical power
supply cable support
Before staring to work with the appliance, it is recom-
mended that the power cable (1) is inserted into the
support (2). This allows the cable to be kept at an
appropriate distance from the appliance prevent-ing
any damage.
The height of the support can be adjusted; remove
the cotter pin (3), raise or lower the rod until the re-
quired position has been reached. Insert the cotter
pin again.
1
1
2
3
