Klimawent
– the warranty of highest quality at attractive price
6 z 8
Filtering unit
HARD-1000-S
16.10.2019
Taking into account the activated carbon weight (in the filter) and its absorptivity, operator can assume roughly,
that the carbon ought to be replaced after absorbing approx. 5 kg of gases.
To replace the activated carbon unscrew the bolts pressing the cassettes against the guide profiles. Subsequently,
draw out the cassette and remove the worn out carbon. Put in the new carbon and distribute evenly the carbon
mass within the whole cassette.
CAUTION
:
Activated carbon ought to be disposed in accordance with the
local regulations.
REPLACEABLE FILTERS
Table No.2
– Pre-filter paint stop
Type
Weight
Dimensions
Class
Efficiency
[kg]
[mm]
[%]
PS-HARD-2000-S
0.5
700x740x50
G3
90-95
Table No.3
– Pocket filter
Table No.4
– High-efficiency filter HEPA
Table No.5
– Granulated activated carbon
TROUBLESHOOTING GUIDE
Table No.6
Problem
Possible reason
Corrective action
1
. the flow capacity of the fan decre-
the “paint-stop” nonwoven (spun- replace the “paint-stop” nonwoven
ases, whereby the signal lamps
bond) is polluted excessively
(spunbond) for a new
are not lighted
2
. the fan flow capacity decreases,
pocket filter is excessively polluted replace the pocket filter for a new
whereby the
H1
lamp is on
3
. the fan flow capacity decreases,
high-efficiency filter is excessively replace the high-efficiency filter
whereby the
H3
lamp is on
polluted
4
. unpleasant smell / odour is percep- activated carbon bed is oversatu- replace the activated carbon in the
tible near the filtering unit
rated
cassette
5
. vibrations of the appliance occur
the fan impeller is faulty
replace the impeller for new
MAINTENANCE AND REPAIR
Every 12 months, within the scope of periodical technical revision, check the technical state of the fan, with
reference to detailed rules of use of electrical drive devices. During the maintenance, examine the mechanical
and electrical connections.
Technical revisions and any maintenance should be performed after the filtering
unit is disconnected
from the power supply
.
OCCUPATIONAL HEALTH AND SAFETY
Start-up and maintenance are exclusively possible after getting acquainted with the contents of the present Use
and Maintenance Manual.
Circuits of the interface sockets ought to be equipped with appropriate short-
circuit- and current-difference protections
(
see Connection Diagram
).
Type
Weight
Dimensions
Class
Efficiency
[kg]
A
x
B
x
H
x
T
[mm]
[%]
FK-HARD-2000-S
2,3
610x610x360x20
F8
90
Type
Weight
Dimensions
Class
Efficiency
[kg]
A
x
B
x
H
[mm]
[%]
FK-HARD-1000-S
6,5
610x610x80
H13
99,95
Type
Weight
Remarks
[kg]
ORGANOSORB 10CO 4x8
20
The cassette contains a total volume of the
activated carbon: 20 kg.
Activated carbon is delivered in bulk along with
the device