Klimawent
– the warranty of highest quality at attractive price
4 z 8
Filtering unit
HARD-1000-S
16.10.2019
ASSEMBLY AND STARTUP
Before the use, install the ERGO LUX extraction
arm or a hose on the HARD-1000-S filtering unit.
For
this
purpose
are
implemented
two
connections
Ø125 mm or one connection Ø160
mm (see Fig. No.3). After suitable connection
fitting pieces are installed, it is possible to fasten
flexible hoses.
Flexible hose should be fastened by means of a
DC coupling.
Brackets, ERGO LUX extraction
arms and hoses do not belong to the acces-
sory set of the filtering unit
(they should be
ordered as additional equipment).
Subsequent steps before the startup
:
Fig. No.3
– Connections
1
. remove two cover discs from the device top;
2
. slide out the
HEPA
high-efficiency filter and the
FK
pocket filter;
3
. screw out (inside the filtering unit) the blocking bolts of the activated carbon cassette (the wrench is enclo-
sed to the delivery);
4
. slide out the cassettes with activated carbon;
5
. fill out the cassettes with activated carbon (delivered along with the filtering unit), up to the level
– of
approx.10 mm below the upper edge of the cassette; important is that the activated carbon is distributed
evenly along the side walls of the cassettes and gently pressed down to make it more dense;
6
. load the cassettes back into the device. Handle with care, as the fragile sealings would not get damaged
while sliding the cassettes in. Mind that the carbon would not get displaced aside, showing empty places
within the cassettes;
7
. insert back the
HEPA
high-efficiency filter and the
FK
pocket filter;
8
. close the covers.
At that point, the filtering unit is ready for operation. To start the device connect the plug into socket 230V/50Hz
and turn on the motor protective switch.
Fig. No.4
– HARD-1000-S – Connection diagram