6
dust separator
EGO-2
;
EGO-4
11.10.2019
Fig. No.4
– EGO – Connection Diagram
7. Operational Use
Within the scope of maintenance, systematically empty the lower waste bag when it is filled up,
whereas, the bag filter needs shaking after certain time - to discard the dusts deposited on the
internal surface of the filter. The cartridge is cleaned by striking it around from outside.
The impurities (deposited on the internal filter surface) fall into the waste bag. The waste bag
must be emptied when the content of impurities riches the level 20 cm below the bag fastening
fitting piece.
In case the hose got clogged (jammed)
– lift the stretched hose above
the
head of connections
and shake.
When to one EGO separator are connected several processing machines
– shut the slide dam-
pers at hoses of the not used machines. This provides a better extraction effect from the other
(active) processing machines.
8. Troubleshooting Guide
Table No.6
Problem
Possible reason
Corrective action
1.
Sudden noise and vibrations A larger piece of wood, knot Disconnect the device from
are occurring
clipping got jammed between the power system, remove
the impeller blades and the
the head of connections and
housing
take out the obstacle by hand
If difficulty, unscrew the
motor flange, take off the
motor and impeller and remo-
ve the object
2.
Extraction efficiency is regu-
A thick layer of dust deposi-
Shake, strike manually the
larly dropping.
ted on the internal surface
bag filter to remove the impu-
of the filter
rities
3.
Lack of suction in one of the
Jam (clogging) in the hose
Stretch the hose, lift it above
hose branches (connections),
the connection head and
is occurring.
shake slightly
4.
Lowered extraction efficiency Opposite motor rotation sen- Change the phase connection
along with the increased noise se
sequence in the power supply
5.
Impurities emerged outside
1
. The bag filter or waste bag
1
. Replace the bag filter or
the device
is damaged
the waste bag
2
. The connection clamp/hoop
2
. Tighten up the clamp or
got released
replace it for a new
