X3-KIT
Installation and Operation Manual
PG 8/40
REV: BETA (4/25/2019)
4.
Application Chart
4.1.
100% Direct Bolt-On Vehicle List
X3-KIT is a 100% direct bolt-on aftermarket product for Can-Am vehicles listed in below chart; every effort has
been made to verify correct fitment on these vehicles in their factory, non-modified conditions.
MODEL YR
MODEL
DRIVE
ENGINE
BODY
TRIM
2017-2019
MAVERICK X3
ALL
ALL
ALL
ALL**
NOTE: All vehicles listed may require drilling holes for ground wires and installing switches, based on
preference of installed switch locations and wire grounding points.
4.2.
**Excluded Vehicles
4.2.1.
N/A
4.3.
Aftermarket Product Compatibility
4.3.1.
This kit has been designed to be compatible with following products from leading manufacturers:
•
Aftermarket cages that discard OE rearmost bolt-on chassis tubes (i.e., rear deck down tubes)
•
Aftermarket front shock tower braces and bulkheads (i.e., S3 PowerSports), which bolt ONLY in front of
shocks, or below frame (i.e., cannot attach above sway bar bolts)
4.3.2.
This kit has NOT been designed
to be compatible with any of the following products:
•
Exhaust systems or high-performance intake systems, including super/turbo chargers
•
Suspension systems (i.e., larger shocks/springs, control arms, sway bar upgrades, etc.)
•
Winches
•
Oversized tires
•
Oversize rear fenders
•
Many other systems/parts no listed
NOTE: Review this manual in full before unpacking items and verify correct space and mounting locations
exist with your aftermarket product(s).
To install this kit alongside your other aftermarket product(s),
modification to included parts, your vehicle, or aftermarket product(s) may be required.
End of Section
